Control Panel On The S120 Business Server Cabinet; Function Of The Indicators - Fujitsu S120 Series Operating Manual

Control panel on the S120 Business Server cabinet

4.1 Control panel on the S120 Business Server cabinet
The control panel is connected with the service processor (SVP) in the S120 Business
Server. The physical structure of the control panel is illustrated in the following diagram:
POWER
COMPLETE
Figure 5: Control panel on the cabinet of the S120 Business Server
The functions of the indicators and control elements on the control panel are described
below.

4.1.1 Function of the indicators

STATUS
The STATUS indicator is an LCD display and can show alphanumeric characters. The
codes change when the Business Server and the IMPL are switched on. No P codes
should be displayed if POWER ON or IMPL has been run without errors (see next
page). If this is not the case, this indicates a malfunction and you should contact the
service department.
14
CHECK
SYSTEM
POWER ON
BACK LIGHT
CANCEL/
ALARM STOP
Controls and indicators
UNIT
EMERGENCY
STAND-BY
IMPL
U41182-J-Z126-1-74
I
o
POWER
OFF