For M9000 server (See
a. Remove the tape drive unit. (See
b. Remove the CD-RW/DVD-RW drive unit. (See
c. Remove I/O units #0, #2, and #4 (IOU#0, IOU#2, and IOU#4) on the right side of
the CD-RW/DVD-RW drive unit. A filler panel may be mounted depending on the
option configuration. (See
9. Remove the MEDBP to be replaced.
a. Using a Phillips screwdriver, loosen the two thumb screws securing the MEDBP.
b. Slide the MEDBP to the right.
c. Disconnect the two cables connected to the rear of the MEDBP.
Note – Be sure to press both lock release buttons inward and pull the connector when
removing the SAS cable (lock release buttons of the connector are yellow).
d. Along the guide, and remove MEDBP carefully
):
FIGURE 22-5
Chapter
15)
Chapter
7)
Chapter 22
Chapter
14)
Media Backplane Replacement
22-7