Reactivating A Hardware Raid Boot Volume - Fujitsu SPARC Enterprise M8000 Service Manual

Caution – Align the PCI card with the slot guides, insert it carefully, and secure it firmly.
Caution – Do not forcibly push the PCI card when inserting it, even if it is not moving
smoothly. You may fail to insert the PCI card due to the presence of any obstruction in a slot
or any problem with a connector pin; and if you forcibly insert it, serious damage may result.
12. Switch on all main line switches for the AC section (ACS) in the power supply
system.
13. Confirm that the XSCF STANDBY LED (green) on the operator panel remains lit.
If it is blinking, wait until it remains lit.
14. Use one of the following methods to start (power on) all domains at once.
■
■
The power to all the domains is turned on, and then the power-on self test (POST) is
executed. When ok prompt displayed on the console of relevant domain, POST is
completed.
For details of the power-on operation, see
page
User's Guide.
15. Restore the original mode switch setting on the operator panel.
Note – When the maintenance work is completed, be sure to confirm the mode switch
setting and return the switch to Locked.
16. Close the door on the server, and lock it.
13.5

Reactivating a Hardware RAID Boot Volume

This section explains how to reactivate a hardware RAID boot volume after replacing the
RAID-capable IOUA on an M8000/M9000 server. Non-boot RAID volumes can be
reactivated after booting with the Oracle Solaris raidctl command.
Press and hold down (for less than four seconds) the POWER switch on the operator
panel.
From a console that is connected to XSCF, execute the poweron -a command of
XSCF.
4-22, and the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
Section 4.4.2, "Powering the Server On" on
Chapter 13 PCI Slot Device Replacement 13-25