Conversion And Reuse Of This Product; Tools Required For Maintenance - Fujitsu SPARC ENTERPRISE M9000 Service Manual

1.2.3

Conversion and Reuse of This Product

If this product is converted or a used article of this product is overhauled for the
purpose of reuse, unexpected injury on users and bystanders or damage to their
property may result.
1.3

Tools Required for Maintenance

The maintenance work described in
software to confirm that the SPARC Enterprise and other components are operating
correctly and to collect status information and log data about the server and
components. The work for mounting, removing, or replacing a specific component
requires screwdrivers, and special tools such as an antistatic wrist strap. These items
are listed in
Maintenance Tools
TABLE 1-1
No. Name
1 Torque wrench
[8.24 N*m (84 kgf*cm)]
2 Sockets for 10 mm (M6) torque
wrench
3 Sockets for 13 mm (M8) torque
wrench
4 Torque wrench extension
5 Torque screwdriver
[0.2 N*m (2.0 kgf*cm)]
6 Slotted bit
7 Wrist strap
8 Conductive mat
9 CPU module replacement tool
10 SunVTS
.
TABLE 1-1
Use
Used to fix the bus bars of the power cabinet.
Used to replace the BP_A in the SPARC Enterprise M8000
server.
Used to fix the bus bars of the power cabinet.
Used to secure the clock cables between the cabinets if the
expansion cabinet of the SPARC Enterprise M9000 server is
mounted.
Used to secure the clock cables between the cabinets if the
expansion cabinet of the SPARC Enterprise M9000 server is
mounted.
For antistatic purposes
For antistatic purposes
For mounting and removing CPU Modules (accessory)
Test program
Chapter 6 to Chapter 24
Chapter 1 Safety and Tools
requires maintenance
1-5