Setting Up The Authenticator; Cisco® 2950 Ios - Extreme Networks Sentriant AG Software User's Manual

802.1X Quarantine Method
6 Select the Enable IEE 802.1X authentication check box.
7 Select an EAP type from the Choose a network authentication method drop-down list. For this
example, select Protected EAP (PEAP).
8 Clear or select the Cache user information for subsequent connections to this network check box.
The choice is yours.
9 Click OK.
10 Select to reboot if prompted.

Setting up the Authenticator

This section provides sample configurations for the following switches:
"Cisco® 2950 IOS" on page 248
●
"Cisco® 4006 CatOS" on page 249
●
"Enterasys® Matrix 1H582-25" on page 249
●
"Extreme Networks® Summit 48si" on page 250
●
"ExtremeWare" on page 251
●
"ExtremeXOS" on page 251
●
"Foundry® FastIron® Edge 2402" on page 252
●
"HP ProCurve 420AP" on page 252
●
"HP ProCurve 530AP" on page 253
●
"HP ProCurve 3400/3500/5400" on page 254
●
"Nortel® 5510" on page 254
●
The lines that apply to 802.1X are shown in
when configuring your switch.
Cisco® 2950 IOS
aaa new-model
aaa authentication dot1x default group radius
aaa authorization network default group radius
dot1x system-auth-control
interface FastEthernet0/1
switchport mode access
dot1x port-control auto
dot1x timeout quiet-period 30
dot1x guest-vlan 5
dot1x reauthentication
spanning-tree portfast
!
interface FastEthernet0/2
switchport mode access
dot1x port-control auto
dot1x timeout quiet-period 30
248
green italic text. Make sure that you add this information
Sentriant AG Software Users Guide, Version 5.3