Extreme Networks Sentriant AG Software User's Manual page 90

System Configuration
1 Enter the IP address of the Cisco CatOS device in the IP address text field.
2 Enter a shared secret in the Shared secret text field. The shared secret is used to encrypt and sign
packets between the device and RADIUS server.
3 Re-enter the shared secret in the Re-enter shared secret text field.
4 Enter an alias for this device that appears in log files in the Short name text field.
5 Select Cisco CatOS from the Device type drop-down list.
6 Select telnet or SSH from the Connection method drop-down list.
7 Enter the User name with which to log into the device's console.
8 Enter the Password with which to log into the device's console.
9 Re-enter the console password.
10 Enter the password with which to enter enable mode.
11 Re-enter the enable mode password.
12 Enter the networks (using CIDR notation) that this device is in direct control over in the Network
list text field. This is only necessary if the device does not send its IP address with its supplicant
request.
13 Enter the Cisco port mask in the text field. This specifies which characters within the endpoint
identifier returned by the Cisco device contain the bank and port information of the endpoint. All
offsets start at 0, so a mask of 2/34 indicates character 3 for the bank and characters 4 and 5 for the
port. If the Cisco device were to return 50210 for an endpoint, a port mask of 2/34 would indicate
that the endpoint is on bank 2 and port 10 (2/10), where 210 are the third, fourth and fifth bytes in
the identifier.
14 Enter the Reconnect idle time. This is the amount of time in milliseconds that a telnet /SSH console
can remain idle or unused before it is reset.
15 Select the Show scripts plus symbol to show the following scripts:
Initialization script—The expect script used to log into the console and enter enable mode.
■
Re-authentication script—The expect script used to perform endpoint re-authentication.
■
Exit script—The expect script used to exit the console.
■
16 Click ok.
NOTE
Click revert to defaults to restore the default settings.
90
Sentriant AG Software Users Guide, Version 5.3