Using The Proxy Server - Konica Minolta bizhub C754 User Manual

7.5 Configuring the WS scan environment
Settings
[Friendly Name]
[Publication Service]
2
In the administrator mode, select [Network] - [DPWS Settings] - [Scanner Settings], then configure the
following settings.
Settings
[Scan Function]
[Scanner Name]
[Scanner Location]
[Scanner Information]
[Connection Timeout]

Using the proxy server

Configure settings for scanning through this machine in the environment where the multicast communication
is restricted using the discovery proxy defined by WS-Discovery. Configure the setting if your environment
requires the discovery proxy server.
In normal circumstances, to perform scan transmission through this machine using the Web service, the
computer must be connected at a location where multicast communication is available for this machine.
However, installing the discovery proxy server at a location where unicast communication is available for this
machine enables it to perform scan transmission.
bizhub C754/C654
Description
Enter the name of this machine to be displayed when searching for this ma-
chine using the Web service through a computer, (using up to 62 charac-
ters, excluding spaces).
Use a name that helps you easily identify this machine.
When using this machine in one of the following environments, select [En-
able].
• Environment where NetBIOS is disabled on the computer loaded with
Windows Vista or later
• Environment constructed so that only communications using IPv6 are
allowed.
Up to 512 destinations can be detected in Publication Service (including
detection counts by NetBIOS).
[Disable] is specified by default.
Description
Select [ON] to use the WS scan transmission function.
[OFF] is specified by default.
Enter the name of this machine when using it as a WS scanner, (using up
to 63 characters, excluding \, !, ,, and a space).
If necessary, enter the location where to install the scanner, (using up to 63
characters, excluding spaces).
If necessary, enter scanner information (using up to 63 characters, exclud-
ing spaces).
Change the time-out time to limit a communication with the computer if
necessary.
[120] sec. is specified by default.
7
7-23