14.10.4 Configuring The Original Size Detection Settings - Konica Minolta bizhub C754 User Manual

14.10 Setting the operating environment for this machine
Settings
[Default Address Display
Method]

14.10.4 Configuring the original size detection settings

Specify the detection capability setting of original size in the Original Glass and the Foolscap paper size set-
ting.
Tips
- The service settings are required for configuring these settings. Contact your service representative in
advance.
In the administrator mode, select [System Settings] - [Standard Size Setting], then configure the following set-
tings.
Settings
[Original Glass Original
Size Detect]
[Size detection (8
1/2e14/Foolscap)]
[Foolscap Size Setting]
bizhub C754/C654
Description
Select the button or list type to display destinations.
[One-Touch Button Layout] is specified by default.
Description
Specify the size detection capability of Original Glass of this machine.
Select a setting table with which the sensor should detect the original size
using the detected numeric values when scanning originals with the Orig-
inal Glass.
[Table 1] is specified by default.
Select which original size is to be recognized between Legal and Foolscap
when scanning an original of approximately 14 inches.
[8 1/2 e 14] is specified by default.
This setting is displayed only in the European model.
Select which original size is to be recognized when scanning an original of
approximately 13 inches.
[8 e 13] is specified by default.
14
14-37