Konica Minolta bizhub C754 User Manual page 305

14.6 Managing the machine via SNMP
2
To notify of the machine status using SNMP TRAP function, select in the administrator mode [Mainte-
nance] - [Status Notification Setting] - [IP Address] or [IPX Address] - [Edit], then configure the following
settings.
Settings
[Notification Address]
[Port Number]
[Node Address]
[Community Name]
[Replenish Paper Tray]
[JAM]
[PM Call]
[Replace Staples]
[Replenish Toner]
[Finisher Tray Full]
[Service Call]
[Job Finished]
[Hole-Punch Scrap Box
Full]
[Waste Toner Box Full]
[Imaging Unit Yield]
bizhub C754/C654
Description
Specify the address to be notified of the machine status.
• If [IP Address] is used as the destination, enter the IP address (IPv4), IP
address (IPv6), or host name (using up to 253 characters).
• If the destination is an [IPX Address], enter the address by an 8-digit
hexadecimal number.
If the destination is an [IP Address], change the port number if necessary.
Normally, you can use the original port number.
If the destination is an [IPX Address], enter the node address by an 12-digit
hexadecimal number.
Enter the community name (using up to 15 characters).
Select this check box to send a notification when paper on tray runs out.
Select this check box to send a notification when paper jam occurs.
Select this check box to send a notification when periodic inspection is re-
quired.
Select this check box to send a notification when staples run out.
Select this check box to send a notification when toner runs out.
Select this check box to send a notification when the finisher tray is full.
Select this check box to send a notification when a service call occurs.
Select this check box to send a notification when a job is completed.
Select this check box to send a notification when hole-punch scrap must
be removed.
Select this check box to send a notification when the waste toner box must
be replaced.
Select this check box to send a notification when the imaging unit must be
replaced.
14
14-25