Registration Roll Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.42 Registration Roll Assembly

(See "Registration" on page -271)

4.2.42.1 Removal

1. Remove the Registration Chute Assembly. ("Registration Chute
Assembly" on page -188)
2. Remove the E ring fro the rear of the Registration Roll Shaft.
3. Slide the Shaft to the rear to free the front of the Shaft from the front
bearing.
4. Remove the Registration Roll Assembly.

4.2.42.2 Installation

1. Make sure both the front and rear bearings are in place in the frame.
2. Slide the rear of the Registration Roll Shaft through the rear bearing.
3. Slide the front of the Shaft to the front bearing.
4. Use one E ring to secure the rear of the Shaft to the rear bearing.
5. Reinstall the Registration Chute Assembly. ("Registration Chute
Assembly" on page -188)
Rev.B
Chapter 4
Figure 4-57. Removal of Registration Roll Assembly
Disassembly and Assembly
189