Msi Friction Clutch; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.31 MSI Friction Clutch

(See "Upper Feeder Assembly" on page -267)

4.2.31.1 Removal

1. Remove the MSI Tray Assembly. ("MSI Tray Assembly" on
page -164)
2. Remove the E ring securing the Clutch to the shaft.
3. Rotate the Clutch clockwise as you pull the it off of the shaft.

4.2.31.2 Installation

1. Make sure the Spacer is in place on the Clutch shaft.
2. Rotate the Spacer so the tabs on the Spacer mesh with the notches
on the Clutch Gear.
When performing step3, push only the rear of the
Clutch. Never press the sides of the Clutch. Pressing
the sides of the Clutch will cause the Clutch break
apart.
3. Slide the Friction Clutch onto the shaft, rotating the Clutch as you
slide it toward the Spacer.
4. Make sure the Clutch and Spacer mesh.
5. Use one E ring to secure the Clutch to the shaft.
6. Reinstall the MSI Tray Assembly. ("MSI Tray Assembly" on
page -164)
Rev.B
Chapter 4 Disassembly and Assembly
Figure 4-45. Removal of MSI Friction Clutch
176