Support Assembly Spring; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.12 Support Assembly Spring

(See "Retard and Take Away-Tray 1" on page -260)

4.2.12.1 Removal

1. Remove Tray 1 Lift Up Motor. ("Tray 1 Lift Up Motor" on page -144)
2. Remove the screw securing the Support Assembly Spring to the
printer frame, and remove the Spring.
Figure 4-21. Removal of Support Assembly Spring
Rev.B
Chapter 4

4.2.12.2 Installation

1. Reinstall the Support Assembly Spring. (Refer to the figure for
correct positioning).
2. Make sure the front and rear arms of the Spring are positioned as
shown in the figure.
3. Use one screw to secure the Spring to the frame.
4. Reinstall Tray 1 Lift Up Motor. ("Tray 1 Lift Up Motor" on page -144)
Disassembly and Assembly
152