Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+
Figure 4-18. Removal of Tray1 Take Away Roll Assembly
15. Remove the Support Assembly Spring. ("Support Assembly Spring"
on page -152)
16. Remove Tray 1 Feed Clutch, along with the Gear and Bearing.
("Tray 1 Feed Clutch" on page -145)
17. Remove the four screws securing Tray 1 Take Away Roll Assembly
to the rear of the frame.
18. Remove the two screws securing Tray 1 Take Away Roll Assembly
to the front of the frame.
19. Locate the two plastic mounting pins, located at each end of the
Assembly, that secure the top of the Assembly to the bottom of the
printer frame.
20. Press the two plastic mounting pins out of the mounting holes, and
pull Tray 1 Take Away Assembly away from the printer.
Rev.B
Chapter 4

4.2.10.2 Installation

1. Reinstall Tray 1 Take Away Roll Assembly onto the bottom of the
printer frame.
2. Align the two plastic mounting pins, located on the top of the
Assembly, with the two mounting holes located in the bottom of the
printer frame.
3. Press the Assembly into the frame so the mounting pins snap into
the holes.
4. Use two screws to secure the front of the Assembly to the printer
frame.
5. Use four screws to secure the rear of the Assembly to the printer
frame.
6. Reinstall Tray 1 Feed Clutch, along with the Gear and Bearing.
("Tray 1 Feed Clutch" on page -145)
7. Reinstall the Support Assembly Spring. ("Support Assembly Spring"
on page -152)
The following steps has you lift the printer. The printer
is very heavy and requires two people to lift it. Do not
attempt to lift the printer by yourself.
8. Set the printer onto Tray 2.
9. Reinstall Tray 1 Lift Motor. ("Tray 1 Lift Up Motor" on page -144)
10. Reinstall the retaining clip that is located under the Option
Connector Bracket, and use one screw to secure the clip.
Disassembly and Assembly
148