Offset Roller Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.56 Offset Roller Assembly

(See "Offset Roller" on page -278)

4.2.56.1 Removal

1. Remove the Offset Drive Assembly. ("Exit Drive Assembly" on
page -201)
2. Remove the Offset Motor. ("Offset Motor" on page -203)
3. Remove the Face Up Exit Sensor. ("Face Up Exit Sensor" on
page -204)
4. Remove the Gear located at the end of the Roller Assembly.
5. Remove the K clip securing the Roller shaft to the rear bearing.
6. Slide the bearing out of the Offset Assembly frame.
7. Slide the front bearing out the Assembly frame, and remove the
Offset Roller Assembly.

4.2.56.2 Installation

1. Slide the rear of the Roller shaft through the rear bearing cutout in
the Assembly frame.
2. Insert the front bearing, still attached to the front of the shaft, into the
front bearing cutout in the Assembly frame.
3. Use a K clip to secure the shaft to the rear bearing.
4. Reinstall the Gear onto the rear of the shaft. The Gear snaps into
place.
Rev.B
Chapter 4
5. Reinstall the Face Up Exit Sensor. ("Face Up Exit Sensor" on
page -204)
6. Reinstall the Offset Motor. ("Offset Roller Assembly" on page -205)
7. Reinstall the Offset Drive Assembly. ("Exit Drive Assembly" on
page -201)
Figure 4-71. Removal of Offset Roller Assembly
Disassembly and Assembly
205