Fuser Full Cover; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.1 Fuser Full Cover

(See "Top Cover Assembly" on page -253 )

4.2.1.1 Removal

1. Remove the Mailbox or the HCS if either are installed.
2. Open the Duplex Unit if one is installed.
3. Open the Left Upper Cover Assembly and remove the screw
securing the Fuser Cover to the frame. (See the figure below)
4. Open the Front Left Cover and remove the screw securing the
Fuser Cover to the frame. (See the figure below)
5. Lift the Fuser Cover off of the Top Cover Assembly.
Figure 4-7. Fuser Full Cover Removal
Rev.B
Chapter 4

4.2.1.2 Installation

1. Open the Duplex Unit if one is installed.
2. Open the Left Upper Cover.
3. Slide the tabs that are located at both ends of the Cover into the
corresponding openings in the Top Cover Assembly. (See the figure
below)
4. Lower the Fuser Full Cover onto the Fuser Assembly.
5. Press the Fuser Full Cover into place. Make sure the tabs remain in
place, the Fuser Full Cover meshes smoothly with the Top Cover,
and the two screw holes in the Fuser Full Cover line up with the
holes in the printer frame.
6. Use two screws to secure the Fuser Full Cover.
Figure 4-8. Tabs of Fuser Full Cover
Disassembly and Assembly
138