Installation - Epson EPL-N4000 Service Manual

Hide thumbs Also See for EPL-N4000:
Table of Contents

Advertisement

EPSON EPL-N4000/EPL-N4000+

4.2.50.2 Installation

1. Reinstall the Fuser Drive Assembly onto the printer frame. (Refer to
the figure for correct positioning)
2. Align the Assembly so the screw holes and locating holes in the
Assembly line up with the screw holes and locating tabs on the
frame.
3. Use two screws to secure the Assembly to the frame.
4. Reinstall the green ground wire to the printer frame, and use one
screw to secure the wire.
5. Reconnect J104, J600, and J602.
6. Reinstall P204 wire harness to the Fuser Drive Assembly.
7. Reconnect FB (red wire) to the HVPS and secure the wire harness
under the harness clips.
8. Reconnect J23 to the AC Driver PWB and secure the wire harness
under the harness clips.
9. Reinstall the Offset Unit Assembly. ("Offset/Exit Assembly" on
page -200)
10. Reinstall the EP Cartridge. ("EP Cartridge (Toner Cartridge)" on
page -192)
11. Reinstall the Fuser Assembly. ("Fuser Assembly" on page -197)
Rev.B
Chapter 4
Disassembly and Assembly
199

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epl-n4000+

Table of Contents