CONFIDENTIAL
Partial cut operation
When the cutter motor is activated while the mechanism is in the home position, the reset signal
changes from high to low, but the F/P position signal is maintained at high. When the motor
continues to be powered and cutting starts, the F/P position signal changes from high to low. If
the cutter motor is only turned off at this point, the cutter slider assembly movement stops after
a partial cut.
Paper Roll Take-up Assembly
This assembly consists of the take-up frame, journal transmission gear, take-up belt, take-up
pulley, and take-up gear. It assures stable take-up of the paper roll.
Take-up operation
When the journal paper feed motor turns, the journal paper feed motor gear rotates in the
direction, and the rotational force is transmitted to the J/S switching gear and paper feed
reduction gear. This causes the journal transmission gear to rotate in the
Rev. A
Figure 2-37. Partial Cut Operation Timing Chart
Figure 2-38. Paper Roll Take-up Assembly
Mechanism Configuration and Operating Principles 2-23
TM-U950/U950P Technical Manual
direction. Since this