Epson EPL-N4000 Service Manual page 44

EPSON EPL-N4000/EPL-N4000+
Table 1-31. Printer Setting
Menu Item
*1
Setup Menu • Interface
• Time Out
*3
• Standby
• Lang
• Lang
• Sprache
• LINGUA
• LENG
• SPRÅK
• Sprog
• Taal
• KIELI
• Ling
*14
• Panel Lock
*15
• Toner
*16, 17
• Face-up Enable
*7,8
• Multibin
*9
• Stacker
*5
• Total Pages
• SelecType Init
Parallel • Speed
Menu
• Bi-D
*7
• Buffer Size
Rev.B
Value
• Auto , Parallel, Ethernet, Network, AUX
• 60, 0, 5 to 300 step1
• Enable , Disable
• English ,
• Francais
• Deutsch
• ITALIANO
• ESPANOL
• SVENSKA
• Dansk
• Nederl.
• SUOMI (changed in EPL-N4000+)
• Portugues
• Off , On
• E****F, E*** F, E** F, E* F, E
• Off, On
• MailBox, Stacker, Sorter, Multisort
• +Face-down, No Face-down (added in
EPL-N4000+)
• 0 to 99999999 (changed in EPL-N4000+)
• Fast, Normal
• Nibble , ECP, Off
• Normal , Maximum, Minimum
NOTE: *1: EpsonNet WebAssist cannot set/change this item.
*2: Appears only when the Type B interface card is installed.
*3: The STANDBYTIME command (not open) of EJL is also
*2
supported. Its default value is 60 (minutes)
*4: Not displayed on the LCD. Can be set with EJL. Not printed
on the status sheet.
*5: This item is for display only, and the setting cannot be
changed.
*6: This item must be set since installation of the face-up tray is
not automatically recognized. The changed setting becomes
valid after the next warm boot or the power is turned on again.
*7: When changed on the panel or with EJL, these do not
become valid immediately but become valid after warm boot or
at power on again. Displaying on the panel, reading with EJL,
and printing on the status sheet for themselves are immediately
reflected. They are not reflected in the out bin setting range,
F
language, network operation, etc. until warm boot is performed
or the power is turned on again. If they are changed on the panel
or with EJL, be sure to perform warm boot or turn on the power
again. To change more than one of these, change more than
one of them, perform warm boot or turn on the power again once
at the end.
*8: Appears only when the multibin unit is installed and can then
be selected. When the setting is changed to terminate the panel
setting mode, warm boot is performed. After the setting is
changed, the test print menu is not displayed until the panel
setting mode is terminated. It becomes valid after warm boot.
*9: Appears when the Stacker can be selected as the outbin.
CHAPTER 1 Product Description
30