Epson EPL-N4000 Service Manual page 261

EPSON EPL-N4000/EPL-N4000+
Figure 7-19. Other Clutch and Sensor, Offset Mother, Exit Gate
Solenoid
Rev.B
MCU PWB
Table 7-17. Signal Name
Signal Name
CL$FEED1 Controls Tray 1 paper feed. High=No feed. Low=Feed
CL$RGATE Controls Registration Clutch. High=Clutch off.
Low=Clutch on
STS#FSR Fuser Heat Roll temperature. Analog signal.
SNR#FEXIT Monitors paper leaving the Fuser. High=Paper present.
Low=Paper not present
SNR#FUT Monitors paper arriving at the Face Up output tray.
High=Paper not present. Low=Pape present
SOL$GATE Controls Gate Solenoid. High=Face Down output.
Low=Face Up output.
CL$ICCW Controls Inverter CCW Clutch. High=Off. Low=On
CLS$ICW Controls Inverter CW Clutch. High=Off. Low=On
OMOT$FWD Controls forward motion of the Offset Motor. High=On.
Low=Off
OMOT$REV Controls reverse motion of the Offset motor. High=On.
Low=Off
SNR#STK Monitors the Full Stack Sensor. High=Tray full.
Low=Tray not full
Chapter 7 Appendix
Description
247