Feed, Nudger, And Retard Rolls; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.9 Feed, Nudger, and Retard Rolls

(See "Paper Pick Up - Tray 1" on page -259 and "Retard and Take
Away- Tray 2" on page -263)

Use this procedure for Feeders1 and Feeders 2.

Replace the Feeder, Nudger, and Retard Rolls as a
unit.

If Feed Roll is exchanged, be sure to perform
LC1 5 Counter Clear. (See "Panel Setting Mode"
on page -26 and "Maintenance Mode" on
page -46)

4.2.9.1 Removal

1. Remove the paper tray from the appropriate feeder.
2. Press in on the front of the Chute, and remove the Chute.
3. Pull out on the Roll latch and slide the Roll off of the shaft.
4. Repeat step 3 for the remaining two Rolls.

4.2.9.2 Installation

1. Position the Roll with the latch end facing out, and slide the Roll
onto the shaft.
2. Rotate and push the Roll down the shaft until the latch locks the Roll
into place.
3. Repeat steps 1 and 2 for the remaining two Rolls.
Rev.B
Chapter 4
4. Reinstall the Chute by sliding the opening in the rear of the Chute
into the tab on the frame, then slightly squeezing the Chute and
hooking the tab at the front of the Chute into the opening on the
frame.
5. Reinstall the paper tray.
6. Reset the Paper Feeder Usage Log for the feeder with the new
Rolls.
Figure 4-16. Removal of Feed, Nudger&Retard Rolls
Disassembly and Assembly
146