Epson EPL-N4000 Service Manual page 112

EPSON EPL-N4000/EPL-N4000+


Turn Paper LC1 3 (Error)

Explanation
This error appears when A4, LT or B5 size paper is set
portrait(short edge first).

Remedy
Reset the paper landscape(long edge first). The error is
cancelled after closing the cassette.


Can' Print Duplex (Error)

Explanation
This error appears when duplex printing is not available
according to its rules.

Remedy
Pressing "Continue" switch will resume printing, but it will be
one-side printing. If "Auto Error Cancel" is On on the device
error, one-side printing will be resumed after a while. If the error
cause is related to the setting of the paper feed device, duplex
printing may resume after feeding setting is changed.


Paper Set ssss ttt (Error)

Explanation
This error appears when the paper size in the selected paper
feeding device does not match with the paper size which is
about to be printed out.


Invalid Option (Error)

Explanation
Finisher or HDD, which can not be used for this printer, is
installed in the printer.
Rev.B

Remedy
Turn off the power and remove the corresponding optional
device. In case of the options which are supported for this
printer, perform the version up of the firmware.


Collate was disabled (Warning)

Explanation
Due to the lack of memory, all necessary data becomes unable
to be stored, as a result, appointed job printing can not be done.
Or, copy number which exceeds the maximum bin number is
requested.
Only 1 copy from the fist page to the last page is printed.


Check Paper Type (Warning)

Explanation
When paper feeding device and paper type are selected
automatically, this error appears in case that there is no device,
which support both that paper size and paper type, or paper size
matches but not paper type. If paper type and paper size
matches but there is no paper in the device, this becomes Paper
Out error, and this error does not appear.


Outbin Select Error (Warning)

Explanation
According to the rules of paper exit, the appointed paper exit
becomes invalid, and paper is ejected to the other paper exit.
Chapter 3 Troubleshooting
98