Epson EPL-N4000 Service Manual page 38

EPSON EPL-N4000/EPL-N4000+


Form Feed:If Data light is On in the not-ready condition, the
printer prints the received data on the one sheet by
pressing this button. If the plural numbers of printing is
selected, the printer prints out that number.
In case of the data which the control code has not
ended yet, the printer prints out the data, which has
already received.
NOTE: However, if the data light is off, the printer does not eject the
paper.


Continue: Error is canceled by pressing this button, while the
Continue LED light is on. When warning occurs,
warning indication is canceled by pressing this button.


Select type/Alt switch:Ordinary condition, One-touch setting mode1,
2 and select type mode.


Menu switch: The printer goes to the setting mode by
pressing this switch.


Item switch: The printer goes to the previous setting item
by pressing this switch.


Value selection switch:The printer goes to the previous setting item
by pressing this switch.


Enter switch: By pressing this button, the printer goes to
status sheet in the test printing menu.


Reset(Continue): The printer stops printing or resets by
pressing Alt and Continue switches. After
displaying "Reset" on the display, pressing
both switches for 5 seconds lead to "Reset
All" and executes warm boot.
Rev.B

This printer has EEPROM and hard disk drive HDD
(option) inside and records various setting values
and printing data. If the printer is turned off during
this process, writing operation is not guaranteed, and
error occurs when the printer is turned on next time.
Therefore, never turn off the printer at the following
cases;
From the power on to On-line light on.
On-line light is blinking
When the printer is printing(when the paper
transporting motor is in active)

When you want to stop printing, press "On-line
switch" or perform Job Cancel/Reset.
Each switch operation for the panel setting is on the next page.
CHAPTER 1 Product Description
24