Tray 2 Retard Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.21 Tray 2 Retard Assembly

(See "Retard and Take Away- Tray 2" on page -263)

4.2.21.1 Removal

1. Open the Left Lower Cover.
2. Remove the screw securing the Feed In Chute to the Assembly, and
slide the Chute to the front of the Assembly to remove it.
3. Remove the plastic Feed Chute from the Take Away Roll.
4. Unhook the spring from the Retard Support.
5. Remove the screw securing the Gear Stopper to the Assembly, and
move the Stopper out of the way.
6. Remove the E ring securing Gear 22 to the shaft and remove the
Gear.
7. Remove the plastic bearing securing the Take Away Roll Shaft to
the front of the printer frame, and remove the Retard Assembly and
attached Take Away Roll.
8. Remove the Take Away Roll. ("Tray2 Take Away Roll Assembly" on
page -162)

4.2.21.2 Installation

1. Reinstall the Take Away Roll Shaft onto the Retard Support. ("Tray2
Take Away Roll Assembly" on page -162)
2. Reinstall the Retard Assembly and Take Away Roll back into the
printer frame.
3. Reinstall the plastic bearing into the hole at the front of the frame.
Rev.B
Chapter 4
4. Reinstall Gear 22 to the rear of the shaft, and use an E ring to
secure the Gear.
5. Align the screw hole in the Gear Stopper with the screw hole in the
frame, and use one screw to secure the Stopper.
6. Reattach the spring to the Retard Support.
7. Reinstall the plastic Feed Chute to the Take Away Roll.
8. Reinstall the Feed In Chute, and use one screw to secure it to the
Assembly.
Figure 4-31. Removal of Tray2 Retard Assembly
Disassembly and Assembly
163