Adjusting The Paper Guide Plate Cam (Multifeeder Assembly) - Canon NP6330 Service Manual

5. Adjusting the Paper Guide Plate Cam (multifeeder assembly)

Adjust the engagement of the 26T gear 1 and the 26T gear 2 so that, when the
solenoid plate is in contact with the claw of the control ring, the paper guide plate and
the paper guide plate cam are as shown in Figure 5-727.
6. Routing the Timing Belt (multifeeder assembly)
Butt the rack plate of the multifeeder against section A (open condition).
Move the slide volume in the direction of B, and attach the timing belt on the pulley.
COPYRIGHT © 1997 CANON INC.
26T gear 1


     
Paper guide plate
Paper guide plate cam
26T gear 2
Figure 5-727
Timing belt
Pulley
Rack plate
B
Slide volume
Figure 5-728
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 PICK-UP/FEEDING SYSTEM
Control ring
Claw
Solenoid plate
Section A
Pulley
5-59