Disassembly And Assembly; Scanner Drive Assembly - Canon NP6330 Service Manual

V. DISASSEMBLY AND ASSEMBLY
This section explains mechanical characteristics and describes how to
disassemble/assemble the copier.
Be sure to observe the following whenever disassembling/assembling the copier:
1. Disconnect the power plug before starting the work.
2. Unless otherwise shown, assemble the parts by reversing the steps given to
disassemble them.
3. Identify each screw by type (length, diameter) and location.
4. A washer is used for two of the mounting screws on the rear cover to protect against
static electricity; be sure to use the washer when assembling the part.
5. A washer is used for some mounting screws (for grounding wire, varistor) to ensure
correct electrical continuity; be sure to use the washer when assembling the part.
6. As a rule, do not operate the copier while any of its parts is removed.
7. Be sure to turn off the front door switch or the power switch before sliding out the
fixing assembly.
A. Scanner Drive Assembly
1. Removing the Scanner Motor
1) Remove the rear cover.
2) Disconnect the connector J205
COPYRIGHT © 1997 CANON INC.
from the motor driver 1 PCB
Figure 3-501
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 EXPOSURE SYSTEM
.
3-19