Stirring The Toner - Canon NP6330 Service Manual

CHAPTER 9 INSTALLATION
C. Stirring the Toner
No.
1
Connect the power plug.
2
Using the door switch actuator, turn on
the door switch, thereby turning on the
power.
Note:
Check to make sure the feeding
assembly has been unlocking.
Check to make sure that the hopper is
3
securely set inside the copier.
4 Press the service mode switch (SSW)
with a hex key.
• The indicator indicates '[1]'
Execute 'No. 407' in service mode.
• Press the '4' on the keypad, OK key,
'0' and '7' on the keypad, and OK
key in sequence.
9-8
Work
COPYRIGHT © 1997 CANON INC.
Checks/remarks
• Check to make sure that the Add
Paper indicator has turned on open-
ing and closing the copyboard cover.
• Press the keys on the keypad and
the Clear key to make sure that the
correct copy count is indicated.
Note:
If the hopper is not securely set
inside the copier, the developing
assembly will not be supplied with
toner correctly, possibly locking the
hopper motor.
The copier will operate about 6 min,
during which the developing assembly is
supplied with toner from the hopper.
Perform steps 5) and 6) during this
period.
Note:
Do not ever turn off the power or
remove the door switch actuator
while the copier is in operation.
SSW
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)