Table of Contents
Advertisement
G. Function Mode [4]
To start function mode, press '4' (keypad) and the OK key in sequence.
To select an item, press the number (keypad).
•
To exeute the mode, press the OK key.
Note:
You must make sure that the copier is in standby state before executing any of the
items.
No.
401
Use it to reset E000, E001, E002, E003, or
E800.
402
Use it to execute AE automatic adjustment.
403
Use it to adjust the fixing roller nip.
404
Use it to check the LED lamps on the
control panel.
405
Use it to check the activation of the
scanning lamp.
406
Use it to check the activation of the pre-
exposure lamp.
407
Use it to supply toner at time of installation.
408
Use it to cause the developing assembly to
rotate idly.
409
Use it to check the operation of the hopper
motor.
COPYRIGHT © 1997 CANON INC.
Description
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
Remarks
To reset an error code, press the
OK key. A press on the OK key will
initialize the code and turn off the
power switch.
See p. 11-15.
See p. 11-41.
A press on the OK key turn on all
LED lamps on the control panel (for
10 sec).
A press on the OK key turns on the
scanning lamp (for 3 sec).
A press on the OK key turns on the
pre-exposure lamp (for 3 sec).
A press on the OK key starts
supplying of toner from the hopper
to the developing assembly
automatically (for about 6 min): the
operation will stop automatically.
This mode ignores the signal from
the developing toner sensor. If you
start the mode by mistake, be sure
to turn off the power switch
immediately.
A press on the OK key causes the
developing assembly to rotate idly
(for about 6 sec).
A press on the OK key causes the
hopper motor to rotate (for 3 sec).
11-173
Advertisement
Chapters
Table of Contents
Troubleshooting
