Canon NP6330 Service Manual page 345

Adjusting the Slit Plate
Note:
• Use only the slit plate at the front.
• If you must replace the drum unit, be sure to put the slit plate back to the white marking.
1) Turn off the power switch, and disconnect the power plug from the power outlet.
2) Remove the copyboard glass, and move the No.1 mirror mount to the center, where work is facilitated.
3) Adjust the slit plate at the front by referring to the table below.
1
2
A
B
A
B
If you adjusted the slit by loosening the screw
the area from the center to the rear end.,
A 3
Leading edge
Slit adjustment direction
11-4
Rear slit plates
(These plates cannot be adjusted.)
, the change will affect
Image density
Lighter
Darker
1
2
3
4
A B
If you adjusted the slit by loosening the screw
the image end (up to a point about 30 mm from the rear).
A 3
Leading edge
COPYRIGHT © 1997 CANON INC.
, the change will affect
CANON NP6330 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)