Canon NP6330 Service Manual page 324

No.
13
Remove the connector cover.
14
Turn the developing assembly releasing
lever in the direction of the arrow to
unlock the developing assembly.
Disconnect the connector, and remove
the developing assembly. Check the
developing cylinder for scratches and
dirt.
15 Install the developing assembly; then,
connect the connector.
Open the hopper to the front, and shift
16
the feeding assembly releasing lever in
the direction of the arrow to unlock the
developing assembly.
17
Remove the screw, and slide out the
dummy drum to the front.
• You will be using the removed screw
later when installing the drum unit.
18 Look the developing assembly in
position.
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 INSTALLATION
Checks/remarks
Connector cover
Developing assembly
releasing lever
Developing assembly
Screw
Dummy drum
Connector
Developing
assembly
Hopper
Developing
assembly
releasing
lever
Connector
Feeding assembly
releasing lever
9-5