Canon NP6330 Service Manual page 306

7) Remove the E-ring
washers, and spring
8) Remove the E-ring
(front/ rear in common).
9) Remove the end of the wire from the pulley (front/rear in common).
COPYRIGHT © 1997 CANON INC.
from the lifter drive shaft (rear); then, remove the gear
.
Figure 8-614
; then, remove the gear
Figure 8-615
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 PAPER DECK PEDESTAL
, parallel pin, and pulley cover
, two
8-23