Canon NP6330 Service Manual page 90

CHAPTER 3 EXPOSURE SYSTEM
4. Routing the Scanner Cable
Note:
You will need a mirror positioning tool (FY9-3002-000) to route the scanning cable.
The tool is used in common with other models.
To use, loosen the screws, extend the two arms (both front and rear) fully, and tighten
the screws.
1) Move the No. 2 mirror mount so that the No. 2 mirror mount pulley shaft
through the long hole in the side plate.
3-26
Figure 3-517
Figure 3-518
COPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
is in view