Installing The Thermistor; Installing The Thermal Switch - Canon NP6330 Service Manual

CHAPTER 6 FIXING SYSTEM

10. Installing the Thermistor

Check to make sure that the detecting face of the thermistor is in even contact with
the upper fixing roller.
In addition, make sure that the lead wire from the thermistor is not forced taut.
Reference:
You need not adjust the position of the thermistor. If the contact is not even, suspect
deformation of the thermistor spring.

11. Installing the Thermal Switch

Check to make sure that the detecting face of the thermal switch is in even contact
with the upper fixing roller.
Reference:
You need not adjust the position of the thermal switch. If the contact is not even,
suspect deformation of the thermal switch spring.
6-28
Thermistor spring
Upper fixing roller
Thermistor
Figure 6-436
Thermal switch spring
Upper fixing roller
Thermal switch
Figure 6-437
COPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)