Disassembly And Assembly - Canon NP6330 Service Manual

CHAPTER 7 CONTROLS AND EXTERNALS
IV. DISASSEMBLY AND ASSEMBLY
This section explains machanical characteristics and describes how to disassemble
/assemble the copier.
Be sure to observe the following whenever disassembling/assembling the copier:
1. Disconnect the power plug before starting the work.
2. Unless otherwise shown, assemble the parts by reversing the steps given to
disassemble them.
3. Identify each screw by type (length, diameter) and location.
4. A washer is used for two of the mounting screws on the rear cover to protect against
static electricity; be sure to use the washer when assembling the part.
5. A washer is used for some mounting screws (for grounding wire, varistor) to ensure
correct electrical continuity; be sure to use the washer when assembling the part.
6. As a rule, do not operate the copier while any of its parts is removed.
7. Be sure to turn off the front door switch or the power switch before sliding out the
fixing assembly.
7-8
COPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)