Canon NP6330 Service Manual page 309

CHAPTER 8 PAPER DECK PEDESTAL
Note:
Make sure that the front and rear guide plates are attached as follows:
• Perpendicular to the base plate of the deck.
• Parallel to the metal plates at the front and the rear.
4) Place paper in the deck, and slide the deck into the pedestal.
5) Open the right door of the deck.
6) Remove the switch cover.
7) Set the deck size switch
8) Install the switch cover.
9) Attach the size seal to the front cover of the deck.
10) Switch on the copier, and check that the new deck size is indicated in the control
panel.
8-26
to reflect the new paper size.
Figure 8-620
COPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)