TEC SX4T - B B/W Direct Thermal User Manual page 79

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
WARNING!
The cutter is sharp, so care
must be taken not to injure
yourself when handling the
cutter.
CAUTION!
1. Be sure to cut the backing
paper of the label.
Cutting labels will cause
the glue to stick to the
cutter which may affect
the cutter quality and
shorten the cutter life.
2. Use of tag paper when
the thickness exceeds the
specified value may affect
the cutter life.
Cut mode
When the optional Cutter Module is fitted, the media is automatically cut.
A swing cutter and a rotary cutter are available as an option, but they are
used in the same way.
Insert the leading edge of the media into the Media Outlet of the Cutter
Module.
Cutter Module
Media
Media Outlet
13. If the loaded media is direct thermal media (a chemically treated
surface), the media loading procedure is now completed. Close the
Ribbon Shaft Holder Plate, and turn the Head Lever to Lock
position to close. Then, close the Top Cover.
If the media is thermal transfer media, it is also necessary to load a
ribbon. Refer to Section 2.8 Loading the Ribbon.
E2-11
ENGLISH VERSION EO1-33036
2.7 Loading the Media