TEC SX4T - B B/W Direct Thermal User Manual page 266

7. PROGRAM DOWN LOAD
5) Select a device to be required as the default device, and then click the OK button. The
default device setting is completed. This setting will be effective next time you start up
Windows.
Default drive selection
NOTES: 1. When COM1 or COM2 is selected as the default drive, communications parameter
will be fixed as follows; Baud rate: 115200bps, Parity: even, Data Length: 8 bits,
and Stop Bit: 1 bit.
2. The default device is can be set on the main menu screen, however, it will be
cleared at the termination of the download program.
(6) Select the drive directory in which the firmware file (*.ROM) was saved, and the file name to be
downloaded. (File information will be showed on the right side of the screen. Click on the RUN
button.
File name
RUN button
7- 5
EO18-33012A
7.3 FIRMWARE DOWNLOAD
OK button
File Information