TEC SX4T - B B/W Direct Thermal User Manual page 287

10. MAJOR UNIT REPLACEMENT
5) Replace the ribbon motor sensor (take-up) with a new one, then reassemble in the reverse
order of removal. At this time, take care of the following points.
Attach the ribbon motor sensor (take-up) to the ribbon sensor plate (take-up) in the correct
direction.
Fit the positioning tabs of the ribbon sensor plate (take-up) into the positioning holes of the
ribbon motor block.
Ribbon Sensor Plate (Take-up)
Make sure that the gear with slits passes between the sensor portions.
Gear with Slits
NOTE: This photo was taken from the gear side for being visible.
Positioning Tab
10-14
10.6 RIBBON MOTOR SENSORS (TAKE-UP, FEED)
Ribbon Motor Block
Sensor Portion
EO18-33012A
Positioning Hole