TEC SX4T - B B/W Direct Thermal User Manual page 163

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
9) Close the print head block and the ribbon shaft holder plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a
failure of the print head block or damage to the print head.
10) Connect the cutter harness to CN15 on the Main PC Board.
11) Fit the cutter cover on the cutter attachment screws, and fix it to the cutter unit with the two cutter
screws.
NOTE: Be careful not to pinch the cutter harness by the cutter cover.
12) Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.
NOTE: For cleaning the cutter, refer to section 8.
Main PC Board
Cutter Cover
CN15
Cutter Harness
Cutter Screw
Cutter Attachment Screw
4- 6
EO18-33012A
4.1 SWING CUTTER (B-4205-QM)