6. ON LINE MODE
Reset Operation, Parameter Setting, Printer Parameter Fine Adjustment and Dump Mode
NOTE: This section describes the threshold setting for the Feed Gap/Black Mark Sensor, Reset
Operation, and Dump Mode. The procedures of the Parameter Setting and Printer Parameter
Fine Adjustment are described in the System Mode, please refer to Section 5.4 and Section
5.5, respectively.
ON LINE
B-SX4T
PAUSE
B-SX4T
Press and hold the [RESTART] key for 3 seconds or longer.
<1>RESET
[RESTART] key
<2>PARAMETER SET
[RESTART] key
<3>ADJUST SET
[RESTART] key
<4>DUMP MODE
[RESTART] key
Vx.x
[PAUSE] key
Vx.x
[FEED] key
[FEED] key
[FEED] key
[FEED] key
6- 5
6. ON LINE MODE
Reset Operation
Parameter Setting
Printer Parameter Fine
Adjustment
Dump Mode
EO18-33012A