1. UNPACKING
5)
Open the top cover and remove the five pieces of tape. And then, open the ribbon shaft holder
plate to remove the ribbon shaft pad from the printer.
Tape
Tape
6)
In case of the B-SX5T series, take out the rewinder guide plate and two SMW-3x8 screws from
the printer inside. Also, remove the tape from the rewinder unit in the printer.
Rewinder Guide Plate
NOTE: For the installation procedure of the rewinder guide plate, refer to Section 4.3.
OPEN
Ribbon Shaft Holder Plate
Tape
Top Cover
Ribbon Shaft Pad
Rewinder
1- 2
EO18-33012A
1.2 CHECKS
Tape
Tape
SMW-4x8 Screw