TEC SX4T - B B/W Direct Thermal User Manual page 248

5. SYSTEM MODE
(1) Printer IP Address, Gateway IP Address, and Subnet Mask Settings
After selecting the menu set the IP address using the following procedure.
Set the first 3 digit value with the [FEED] or [RESTART] key.
Press the [PAUSE] key to move the cursor to the next 3 digit value.
Set the next values in the same way.
NOTES: 1. Pressing the [FEED] key one time causes a –1 change. Pressing the [RESTART] key
one time causes a +1 change.
2. If holding the [FEED] or [RESTART] key for 0.5 seconds or longer in the parameter
setting, the key is entered continuously.
After the last 3 digit value is set, press the [PAUSE] key. The display will show "GATEWAY IP
ADDRESS". Set the values for the Gateway IP Address and Subnet Mask, respectively.
(2) Socket Port Setting
To set the socket port number, follow the procedure below.
[PAUSE]
[PAUSE]
[PAUSE]
 
Enter each digit of the port
number with the [RESTART]
or [FEED] key.
[PAUSE]
[PAUSE]
 
 
[RESTART]
[FEED]
Select "PORT ON" or "PORT OFF" with the [RESTART]
or [FEED] key. When "PORT ON" is selected, a port
number is displayed. Pressing the [PAUSE] key allows
the port number setting.
[RESTART]
[FEED]
Enter the 5th digit of the port number with the
[RESTART] or [FEED] key.
[PAUSE] key allows the 4th digit setting.
Repeat this procedure until the 1
been completed.
5-59
EO18-33012A
5.9 IP ADDRESS SETTING
Pressing the
st
digit setting has