TEC SX4T - B B/W Direct Thermal User Manual page 169

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
1) Remove the two black screws to detach the front plate. (Refer to section 4.1.)
2) Open the top cover. (Refer to Section 3.1.)
3) Remove the side panel (L) from the printer. (Refer to section 3.2.)
4) Remove the operation panel ass'y from the printer. (Refer to section 3.4.)
5) Attach the rewind paper guide to the base with the two M-4x8 screws.
6) Align the notch of the take-up holder with the screw hole of the rewinder ass'y, and attach them to
the printer with the four SM-4x8B screws and the SM-4x8C screw.
7) Attach the rewind full sensor (LED) to the base with the SM-3x6B screw.
Screw Hole
M-4x8 Screw
4-12
EO18-33012A
4.3 STRIP MODULE (B-9904-H-QM)
Rewind Paper Guide