TEC SX4T - B B/W Direct Thermal User Manual page 197

5. SYSTEM MODE
#
(27) Language selection for LCD message
(28) Auto forward wait
(29) Head up on in cut mode
Rewinder selection
(30) Ribbon saving module
(31) Transmission control code selection
(32) Strip wait status selection
(33) Feed key function
(34) Kanji code type (Not supported QQ/QP models)
(35) Euro font code
(36) Auto print head broken element check
(37) Centronics interface ACK/BUSY timing setting
(38) Web printer function
(39) Input prime selection
(Reset operation when INIT signal is ON)
(40) Ribbon near end detect setting
(41) Expansion I/O interface operating mode
Item
5- 8
5.3 SELF-DIAGNOSTIC TEST
Contents
ENGLISH: English
GERMAN: German
FRENCH: French
DUTCH: Dutch
SPANISH: Spanish
JAPANESE: Japanese
ITALIAN: Italian
ON: Available
OFF: Unavailable
NOTE: The stop position fine
adjustment value is also
printed out.
ON: Available
OFF: Unavailable
ON: Rewinder is used.
OFF: Rewinder is not used.
ON: Available
OFF: Unavailable
AUTO: Automatic selection
ESC LF NUL: ESC LF NUL mode
{ | }: Mainframe mode
xx xx xx: Optional code
(The values are given in HEX.)
ON: Available
OFF: Unavailable
FEED: Feeds one label
PRINT: Prints image buffer on one
label
TYPE 1: Windows code
TYPE 2: Original code
20H to FFH
ON: Available
OFF: Unavailable
TYPE1: The timing of ACK signal
going up matches with that
of the release of BUSY
status.
TYPE2: The timing of ACK signal
going down matches with
that of the release of BUSY
status.
ON: Available
OFF: Unavailable
ON: Available
OFF: Unavailable
30m: Near end is detected when
the remains of the ribbon is
30m long.
70m: Near end is detected when
the remains of the ribbon is
70m long.
OFF: Near end is not detected.
TYPE1: Standard mode
TYPE2: Inline mode
EO18-33012A