5. SYSTEM MODE
Cut Position Fine Adjustment (Example)
NOTES: 1.
Cut issue is available only when the optional cutter unit (B-7208-QM) is installed.
2.
The fine adjustment value equals to the sum of the fine adjustment values set by the
PC command and this parameter.
The maximum cut position fine adjustment value is 50.0mm. When the value
reached the maximum, the value remains unchanged even if the subsequent fine
adjustment is performed.
Strip Position Fine Adjustment (Example)
NOTE: The print stop position when printing the label
in strip mode varies according to label length
as the strip mode printing stops so that the
edge of the strip shaft is 4 mm from the middle
of the gap. This is because the gap length is
programmed as 2 mm. When the gap length is
5 mm or more, the effective print length should
be set to the value obtained by subtracting
2mm from the label pitch, that is, set the gap
length to 2 mm. If the print format hangs over
the gap as a result, correct the print start
position.
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-36
EO18-33012A