TEC SX4T - B B/W Direct Thermal User Manual page 173

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
16) Fix the strip sensor harness with the three cable clamps and connect it to CN20 on the Main PC
board.
Main PC Board
17) Reassemble the side panel (L) in the reverse order of removal.
18) Close the print head block and ribbon shaft holder plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a
failure of the print head block or damage to the print head.
19) When using the printer in batch mode or strip mode, attach the front plate removed in step 1).
20) When using the printer in built-in rewinder mode, attach the rewinder guide plate to the front of the
printer with the two SMW-4x8 screws.
Rewinder Guide Plate
SMW-4x8 Screw
21) Make a test print to check for proper strip issue.
NOTE: If the label skews, refer to section 8.
CN20
Cable Clamp
Strip Sensor Harness
4-16
EO18-33012A
4.3 STRIP MODULE (B-9904-H-QM)
SMW-4x8 Screw