TEC SX4T - B B/W Direct Thermal User Manual page 185

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
1) Loosen the two M-3x5 screws of the LAN interface board. (Refer to Caution above.)
2) Remove the side panel (L) from the printer. (Refer to section 3.2.)
3) Remove the two SM-3x6 screws to remove the blind plate A from the back.
SM-3x6 Screw
NOTE: Keep the blind plate A safe as this will be necessary when the machine is modified to the
standard type.
4) If the PCMCIA interface board is also installed, attach the PCB attachment plate to the plate to
which the PCMCIA interface board is secured with the SM-3x6 screw. If not, go to the next step.
PCMCIA Interface Board
4.7 LAN INTERFACE BOARD (B-9700-LAN-QM)
PCB Attachment Plate
4-28
EO18-33012A
Blind Plate A
SM-3x6 Screw