4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
8) Fit the bush to the longer harness of the rewind full sensor (Tr) and the rewinder harness in the
orientation shown below.
SM-4x8C Screw
Notch
Take-up Holder
Base
9)
Insert the longer harness of the rewind full sensor (Tr) into the hole in the printer frame. Fit the
bush into the hole.
Rewinder Ass'y
Rewind Full Sensor (LED)
SM-3x6B Screw
Frame
SM-4x8B Screw
Bush
Hole
Longer Harness of the Rewind
Full Sensor (Tr)
4-13
4.3 STRIP MODULE (B-9904-H-QM)
Longer Harness of the Rewind
Full Sensor (Tr)
Rewinder Harness
Bush
EO18-33012A
SM-4x8B Screw