TEC SX4T - B B/W Direct Thermal User Manual page 256

6. ON LINE MODE
NOTES: 1. If a command error is found in the command received, 16 bytes of the command error,
starting from the command code, will be displayed. (However, [LF] and [NUL] will not be
displayed.)
Example 1
[ESC] T20 G30 [LF] [NUL]
The following message appears.
T20G30
B-SX4T
Example 2
[ESC] XR; 0200, 0300, 0450, 1200, 1, [LF] [NUL]
The following message appears.
XR;0200,0300,045
B-SX4T
Example 3
[ESC] PC001; 0A00, 0300, 2, 2, A, 00, B [LF] [NUL]
The following message appears.
PC001;0A00,0300,
B-SX4T
2. When the error command is shown, "? (3FH)" appears for codes other than codes 20H to
7FH and A0H to DFH.
Threshold Setting for the Feed Gap/Black Mark Sensor
NOTE: For procedures, please refer to 6.1 THRESHOLD SETTING.
Command error
V1.0A
V1.0A
Command error
V1.0A
ON LINE
B-SX4T
Set a pre-printed label.
[PAUSE] key
PAUSE
B-SX4T
Press and hold the [PAUSE] key for 3 seconds or longer.
TRANSMISSIVE
B-SX4T
REFLECTIVE
B-SX4T
Command error
Vx.x
Vx.x
Threshold setting for the Feed
Gap Sensor
Vx.x
[FEED] key
Threshold setting for the Black
Mark Sensor
Vx.x
6- 4
EO18-33012A
6. ON LINE MODE