TEC SX4T - B B/W Direct Thermal User Manual page 234

5. SYSTEM MODE
Sensor Type Selection
Select the sensor type among "TRANS" (Feed Gap Sensor), "REFLECT" (Black Mark Sensor)
and "NONE".
[RESTART]
[FEED]
After selecting the sensor type, press the [PAUSE] key to go to Printing Mode Selection.
NOTE: Select the sensor type which is proper to the media being used. Basically, the
Reflective Sensor (Black Mark Sensor) is for tag paper, and the Transmissive Sensor
(Feed Gap Sensor) is for label.
Printing Mode Selection
Select the printing mode for the test print between "TRANSFR" (Thermal transfer) and "DIRECT"
(Thermal direct).
[RESTART]
[FEED]
After selecting the printing mode, press the [PAUSE] key to go to Issue Mode Selection.
NOTE: Select the printing mode which is proper to the operating conditions. Basically, the
Thermal Transfer is for the use of ribbon, and the Thermal Direct is for the use of
thermal paper.
Issue Mode Selection
Select the issue mode for the test print among "[S]NO CUT" (Batch mode without cut), "[C]WITH
CUT" (Cut mode), and "[H]PEEL OFF" (Strip mode).
[RESTART]
[FEED]
After selecting the Issue Mode, press the [PAUSE] key to go to Label Length Setting.
NOTE: Cut mode is available only when the optional cutter module (B-4205-QM or B-8204-
QM) is installed. Strip mode is available only when the optional strip module (B-9904-
H-QM) is installed.
None
Black Mark Sensor
Feed Gap Sensor
Thermal Transfer
Thermal Direct
Batch mode without cut
Cut mode
Strip mode
5-45
EO18-33012A
5.6 TEST PRINT