TEC SX4T - B B/W Direct Thermal User Manual page 235

5. SYSTEM MODE
Label Length Setting
Select the label length for the test print in a range from 5 mm to 999 mm.
[RESTART]
[FEED]
[FEED] key:
[RESTART] key: Pressing the [RESTART] key one time causes a +1 mm change, up to 999
After selecting the label length, press the [PAUSE] key to go to Paper Feed Selection.
NOTE: Pressing and holding the [RESTART] or [FEED] key causes the display to show the
values quickly and continuously. To stop it, release the key.
Paper Feed Selection
Select whether or not a paper feed is performed prior to a test print.
[RESTART]
[FEED]
After selecting the paper feed, press the [PAUSE] key. The display returns to the "<4>TEST
PRINT".
NOTE: When "PAPER FEED" is selected, the printer feeds the media prior to a test print to
adjust the print start position. When "PAPER NO FEED" is selected, the printer starts
printing without print start position adjustment. If the print start position adjustment is
unnecessary, you can save the media by selecting "PAPER NO FEED".
Pressing the [FEED] key one time causes a –1 mm change, up to 5 mm.
mm.
Paper feed is available.
Paper feed is not available.
5-46
EO18-33012A
5.6 TEST PRINT